Port redirection to a different port fix.2. Unfortunately this device does not support Bandwidth Limitation per user.Firmware DSL-502T Firmware Release _200704251. To access this feature Navigate to –> Advanced –> Parental Control –> Block Website –> add a rule Yes you can block http sites (not https). (So that when the primary stops working the Failover will kick in.) On this page you will need to Configure the 3G Internet Profile and Set the Primary Internet Source to your current Internet ServiceĪnd the Failover to 3G. You will need to navigate to Advanced –> 3G Internet Setup. If the 4th LAN port does not indicate LAN/WAN then the device can unfortunately not be set up as an Access Point To access this function you will need to edit the WAN Profile to use it as an access point, If the devices 4th LAN (Yellow) Port says LAN/WAN then this device can be used as an access point. Unfortunately this device cannot be used as a Repeater as it does not have this functionally built in. If the Devices 4th LAN (Yellow) Port says LAN/WAN then it can be configured for Fiber connection. Note: You will need to reconfigure the router again to get internet access.Ĭan the Device be used with a Fiber Connection? To Reset the Router, you will need a small object such as a (PIN/Toothpick/Paper Clip) to insert into the “Reset” hole at the back of the device for 15-20 Seconds, until the power light goes Red. If you forgot your login details you will unfortunately need to reset the router back to factory defaults to be able to access the router. I forgot my login password, what do I do? Here you can change the SSID (WiFI Name) and the Network key/WPA Passphrase/WPA Preshared key (these all mean Wi-Fi Password) Login to the routers settings (connect to 10.0.0.2) –> Go to Wireless Connection –> Manual Wireless Connection Setup How do I change the Wi-Fi name and password Please use the password it was change to, then select login. Note: If the popup indicates that the details are incorrect, the default details were changed in the initial setup of the wizard. The default username is usually: “admin”, Password: “admin”
Use the default login details on the back of device. If you have set up the router before a popup will open asking for a username and password. Once you are connected to the device please open your internet browser (chrome, firefox or Internet explorer etc) and type the following address into the address bar “” and then click search/enter. Plug one end of a LAN cable into one of the yellow ports at the back of the router, then plug the other end into a computer or laptop. Feel free to start a live chat with one of our agents or phone our support line at 0
0 kommentar(er)
